Look! The hard to find 40-pin, 80-conductor IDE cable for Ultra DMA/66/100 or 133 Hard Drives is here! Has two 40 pin IDE drive headers (and the 40-pin controller header), so that you can add two IDE drives with this cable!!
Features/Specifications
40-pin, 80-conductor, 3-connector IDE Cable for UDMA/66/100 or 133 Hard Drive Transfer Rate of 66.6 MB/s, 100 MB/s, and 133 MB/s Length: 18 inches 80-Conductor Ribbon Cable 3 x 40-Pin Connectors. Ultra 66/ATA, 100/ATA and 133/ATA IDE. This is a very high end Cable designed for High Speed Ultra DMA IDE Hard Drives. Excellent Cable with Professional Connectors. Connector Spacing: Blue-----------Gray----Black 0"-------------12"-----18" Connectors are color coded, BLUE for controller, BLACK for drive 0 and GRAY for drive 1 What it is: It's an 80 conductor cable with 40 pin connectors that uses the extra ground wires to dampen the noise bleed through between lines. This is the only way to overcome the limiting factors due to noise and crosstalk of the traditional IDE cable. This cable will also enhance Ultra ATA/33 drives up to 95% faster by reducing noise, thus having the drives running at peak performance. Who Likes It: Ultra ATA/66/100/133 is endorsed by all leading hard drive manufacturers, including Western Digital, Fujitsu, IBM, Maxtor, Quantum, Seagate, Toshiba and others. Please check with your hard drive manufacturer to find out if your hard drive is Ultra ATA/33/66/100 or 133. Compatibly: Ultra ATA/66/100/133 is 100 percent backwards compatible with both Ultra ATA/33 and DMA, and with existing EIDE/IDE hard drives, CD-ROM drives and host systems.
Product Requirements
Three connectors for up to two devices It has 80 wires but 39 pins (one blocked), which makes it back compatible with the DMA33 IDE cables Yes, that means this cable will work with an old ATA33 hard drive/motherboard/CD ROM. Check the IDE connector on your motherboards. Ensure that it has 39 pins instead of 40. If it has 40. This cable may or may not work with your motherboard. The connectors are color-coded for ATA66 and Higher. The blue connector is for the motherboard. The middle, grey one must be connected to the master hard drive. The black, end one is for a slave drive if there is one.
Informational Links
http://www.tecchannel.de/hardware/850/1.html http://www.cablesnmor.com/ultra-ata.html
Back to Top	Back to Descriptions